Tx operated helicopter fitting instructions

Fit the bulbs to your aircraft taking care to keep all wires away from hot and or moving parts, secure the control unit near your reciever or any place that will not unbalance your aircraft.

Fit each bulb into the control unit as described in the kit instructions, the diagramme below shows a typical wire installation.

Plug the male Futaba lead into your reciever channel that will operated your landing light, (usually channel 5), you may use the female Futaba lead to operated any other device such as landing gear servo's alongside the landing light.

Secure your 9v PP3 battery to your aircraft in a place easily accessable in order to replace or recharge the battery.

Secure the On/Off switch in a position easily accessable.

Turn your transmitter on, then your aircraft, switch on the lighting, operate your transmitter switch and check the landing light comes on/off matching your switch position, if not, use the switch on the side of the control unit to reverse the channel direction.