aer9

Packed with features, this glow plug driver with visual glow plug condition monitor is a must have for any Rc Aircraft, Car or Boat, single or twin glow engines.

Features

Glow plug condition monitor (Via 2 color single bulb LED)

4000Mah Ni-Mh battery

Rubber glow plug boot

Crash resistent control unit

High end silicon cables and connectors

Easy programming button with LED indicator

No more stripping down your model to check if your glow plug is dead
No more carrying hand held glow starters around
No more ruining your model to fit those remote glow plugs
No more engine stalls due to a low glow
No more starters falling off the glow plug
Takes minutes to fit
Suitable for single or twin engined models

The control unit will run a systems check when the unit is switched on, when the system detects
the glow plug is okay, the LED which can be mounted anywhere on your model will glow GREEN
for GO, if the LED does not go green then your glow plug needs replacing, when you activate the
glow switch on your Tx, the LED will change to RED for HOT indicating the glow plug is on

The glow plug starter is powered via an included 4000Mah 1.2v battery which will give you hours
of continued glow starts and can be easily removed to be charged by any reciever charger or
using our own 1.2v charger

Fitted with a high end rating rubber glow boot which fits neatly and securely to any glow plug
(A straight glow cap is fitted for car and boat engines with a high cylinder head), all the cables are
of quality 18awg silicon with a very high heat point

We always use good quality impact resistent boxes on our control units ensuring that the unit will
survive most crashes, the Rx channel reverse function is handy to change the units direction instead
of having to do so on your transmitter

This system allows the user to programme the exact throttle position the glow turns on and the
exact position it turns off, simply move your throttle stick to the position you want glow on, turn
on your Rx then your Tx, press the set button, the system will then search for your stick position
and store it, move your throttle stick to the position you want glow off then press the set button,
your system is now programmend.